Power system MCQ #6
Power system MCQ 76 to 80:
91) The effect of capacitance can be neglected ________?
(a) Short transmission lines
(b) Medium transmission lines
(c) Long transmission lines
(d) All of these
91) The effect of capacitance can be neglected ________?
(a) Short transmission lines
(b) Medium transmission lines
(c) Long transmission lines
(d) All of these
92)
What are the values of A, B, C, D parameters of a short transmission line?
(a) Z, 0, 1, 1
(b) 1, 1, Z, 0
(c) 1, Z, 0, 1
(d) 0, 1, 1, 1
(a) Z, 0, 1, 1
(b) 1, 1, Z, 0
(c) 1, Z, 0, 1
(d) 0, 1, 1, 1
93)
Which among the following relation is true for a transmission line?
(a) –AB + CD = 1
(b) –AD + BC = 1
(a) –AB + CD = 1
(b) –AD + BC = 1
(c) AB – CD = -1
(d) AD + BC = 1
(d) AD + BC = 1
94)
A line of what length can be classified as a medium transmission line?
(a) 90 – 100 km
(b) 150 – 200 km
(c) 50 – 150 km
(d) Above 200 km
(a) 90 – 100 km
(b) 150 – 200 km
(c) 50 – 150 km
(d) Above 200 km
95)
When is the Ferranti effect on the long transmission lines experienced?
(a) The line is heavily loaded.
(b) The power factor is unity.
(c) The line is fully loaded.
(d) The line is lightly loaded.
(a) The line is heavily loaded.
(b) The power factor is unity.
(c) The line is fully loaded.
(d) The line is lightly loaded.
ANSWER:
| 91-a | 92-c | 93-b | 94-c | 95-d |
Power system MCQ 96 to 100:
96)
The thickness of insulation layer provided on the conductor, in cables
depend on_______.
(a) Operating voltage
(b) Power factor
(c) Current to be carried
(d) All of these
(a) Operating voltage
(b) Power factor
(c) Current to be carried
(d) All of these
97)
In which ______ climate the chances of occurrence of corona is maximum?
(a) Dry
(b) Humid
(c) Winter
(d) Hot summer
(a) Dry
(b) Humid
(c) Winter
(d) Hot summer
98)
The hollow conductors are used because _______?
(a) Improve stability
(b) Reduce the weight of copper
(c) Reduce corona
(d) Increase power transmission capacity
(a) Improve stability
(b) Reduce the weight of copper
(c) Reduce corona
(d) Increase power transmission capacity
99)
Which tests are conducted to locate the fault location in the cables?
(a) Varley loop test
(b) Murray loop test
(c) Both (a) and (b)
(d) None of these
(a) Varley loop test
(b) Murray loop test
(c) Both (a) and (b)
(d) None of these
100) Which part of thermal power plant causes
maximum energy losses?
(a) Condenser
(b) Alternator
(c) Boiler
(d) Ash and unburnt carbon
(a) Condenser
(b) Alternator
(c) Boiler
(d) Ash and unburnt carbon
ANSWER: | 96-a | 97-b | 98-c | 99-c | 100-a |
Power system MCQ 101 to 105:
101) The sending
end voltage of the transmission line controls the
(a) Reactive power
(b) Active power
(c) (a) and (b) both
(d) None of the above
102) The frequency
of the power system control the
(a) Active power
(b) Reactive power
(c) (a) and (b) both
(d) None of them
103) What is the
unit of constant D?
(a) ohm
(b) mho
(c) henry
(d) none of the above
104) In case of
parallel wires, the visual corona begins
(a) At disruptive
critical voltage
(b) At lower voltage than disruptive critical voltage
(c) At visual critical voltage which is higher than disruptive critical voltage
(d) None of the above
105) The voltage
stress in maximum in the cable
(a) At the surface
of the sheath
(b) At the surface of the armouring
(c) At the surface of the insulator
(d) At the surface of the conductor
ANSWER: | 101-a |
102-a | 103-d | 104-c | 105-d |
Leave a Comment